Canadian built... Project Dool-Eh!... Lots of pics

I also wanted to finish the rear crossmember off so I started by building the corner pieces

All welded and prepped

Tacked in place... Was Too busy to snap any pics of it welded and finished

After whipping up a temporary rad support and bolting on the hood and fenders, it was time to load her up and head for the show

I like this shot

Here she is parked at our campsite

Down at the showfield lookin sweet as fuck!

Couple more shots from the show


Loaded up and headed back home

Tucked back in her hole


The vanfest weekend was such a great time. The truck got tons of attention and lots of positive feedback. It was a lot of work to get it to the show but it all came together nicely. Gonna take a break for a few days and recharge my batteries before I figure out what's next on the list to work on

a buddy of mine (green 94 ford ranger with a gm iron duke in it) was at the show and sent me some pic of your truck. truck looks wicked man

that truck is looking beautiful , great skills on the welding , little word of advise make sure you drill a little hole in the lowest part of the springpockets you made in youre front a arms , as they likely turn intoo birdbaths if you dont

dually looks killer bro nice job!

Awesome! It's always so nice to see your project out in the sun for the 1st time, keep up the good work!

truck looks awesome

Looked back through your build and couldn't find an answer, Are you running dually hubs up front or 3/4 ton hubs? Front looks tucked in. Any pics of inside the engine compartment with wheel and tire clearances?

This build is getting better and better! A couple of questions: 1. are you using the single wheel discs up front?, 2. do you have a lowered spindle in the above set up?

Thanks everybody for all the positive feedback!

And to answer the questions above, this started out as a 1 ton SRW truck. Nothing has been swapped in other than some Belltech spindles which I just put on 2 days before the show. All I did was bolt on the adapters and wheels front and back. I will be making some new arms and adding some length into them to get the wheels pushed out a bit

Looking good man!