B2200 Rebuilt top to bottom and going low!

dang man those are some nice parts cant wait to start ordering mine

cant wait till mine are all in lol... I'm hoping to order my full engine rebuild kit by the end of the month, and have a full rolling chassis, with a fully rebuild motor soon... other then a new Weber and headers, ill be ready to move on to the body and interior

Good looking setup on the rear. Did you get your notch issue sorted out? Looks like you found a good (better than mine) angle finder.

I haven't got the notch thing fixed yet, but I got my pinion angles all set, and the axle in place. I plan on getting my 4 link mocked up and test its movement, to make sure the axle does bind and everything is smooth, then I'll know exactly where the axle needs to be and ill fix the notch and upper brackets, that way for some reason should I figure something wrong I'm not fixing it 10000 times

good progress!

just a quick update... not much done on the truck lately.. waiting on parts... but some more did come in the last couple days heres the valves and then the wheel seals

nice man straight looking good

again not a great update, but more parts rolled in today... I got my brand new Slam specialties SS7 airbags... just waiting for the front brackets, and 4 link.... they were supposed to have been shipped out last week, so they should be here any day I'm hoping.... especially because I want to get stuff mocked up this weekend

looking good man

ok so i started to tackle the front of the truck this weekend... dont have the brackets in but wanted to get a head start... heres a few pics of what things are looking like.. advice is welcome thanks

before cutting the uppers...



how much the LCA is up.


and heres what worries me a little bit... is the opening supposed to be this big??


im running flipped lower BJs, stock spindles, and the upper bj is in the stock spot.... and i had to open it up this much to get it to lay frame for an 18, if all my measurements are correct. I haven't set it on the ground yet, only because I don't have the other side as far as this side... but I plan on it before i weld anything up....